Hydraulic UZC tube bending machines are available with 3 or 5 axis with CNC- control. Tube diameters from Ø38 mm up to Ø230 mm.
http://www.uzma.com.tr/en/products-2/itemlist/category/24-cnc-controlled-tube-bending-machines.html
Hydraulic UZC tube bending machines are available with 3 or 5 axis with CNC- control. Tube diameters from Ø38 mm up to Ø230 mm.
http://www.uzma.com.tr/en/products-2/itemlist/category/24-cnc-controlled-tube-bending-machines.html
Hydraulic UZN tube bending machine has NC-control unit with touch schreen. This semi-automatic bending machines combines accesibility and cost efficiency, and still having precise tube bending quality.
UZH tube bending machine is semi-hydraulic, where bending wings movement is with clutch gear and tubes rotation degree is manual set up. Models max. tube diameter 32, 51, 76 and 90 mm. Excellent for small
NC controlled non-mandrel tube bender has capability to bend up to Ø 60mm x 4mm. The controller has 500 programs memory of internal memory and minium radius is three times its radius.
NC controlled non mandrel pipe bender has capability of bending up to Ø 76mm x 3mm pipe. The controller has 500 programs memory of internal memory and minium radius is three times its radius.
https://www.sahinlermetal.com/en/product/172/section-and-pipe-bending/spb-76
German Hatec CNC- plasma cutting machine P-Cut 220 cuts round tubes up to 220 mm diameter and profiles up to 150*150 mm. Plasma source is Hypertherm PowerMax 105 resonator.
Tubes and profiles are loaded from the side inside support kollet. Precise ballscrew guided cutting head moves on x- and z- directions according to CNC program.
G-code drawings can be sent to programming softaware and you can simulate cutting paths and times.
EHRT punching stations are traversing across the bar in Y-direction by CNC. Gripper feeder is introducing the bar in X-direction. EHRT quick change tools for thick material, similiar to Thick Turret type of tools, are mounted in the cassette type tool station sledge.
FlexPunch and Holecut punching machines can use Multitools, like 3in1 or 6in1, which increases the total tool amount upto 28 pieces and also set ups with Quicklock-system becomes faster.
EHRT is offering also automatic bar loading systems, like AMZ loading table or Gantry systems. With fully automatic Gantry system connected to EHRT punching machine, all processing of bars, like storing, punching, tapping, cutting, marking and unloading can be done according to orders with Just-in Time principle without any manual set ups needed.
See more Punching machines | EHRT Maschinenbau GmbH .
The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.